ISO 12460-1-2007

VIP免费

阿拉丁 2024-09-09 8 441.91KB 26 页 12星币

侵权投诉

Reference number

ISO 12460-1:2007(E)

INTERNATIONAL

STANDARD

ISO

12460-1

First edition

2007-09-15

Wood-based panels — Determination of

formaldehyde release —

Part 1:

Formaldehyde emission by

the 1-cubic-metre chamber method

Panneaux à base de bois — Détermination du dégagement de

formaldéhyde —

Partie 1: Méthode du dégagement de formaldéhyde en chambre de

1 mètre cube

ISO 12460-1:2007(E)

PDF disclaimer

This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but

shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In

downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat

accepts no liability in this area.

Adobe is a trademark of Adobe Systems Incorporated.

Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation

parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In

the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.

electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or

ISO's member body in the country of the requester.

ISO copyright office

Case postale 56 • CH-1211 Geneva 20

Tel. + 41 22 749 01 11

Fax + 41 22 749 09 47

E-mail copyright@iso.org

Web www.iso.org

Published in Switzerland

ISO 12460-1:2007(E)

Contents Page

Foreword............................................................................................................................................................ iv

Introduction ........................................................................................................................................................ v

1 Scope ..................................................................................................................................................... 1

2 Normative references ........................................................................................................................... 1

3 Terms and definitions........................................................................................................................... 1

4 Principle................................................................................................................................................. 2

5 Reagents................................................................................................................................................ 3

6 Apparatus .............................................................................................................................................. 3

7 Test pieces ............................................................................................................................................ 9

8 Procedure ............................................................................................................................................ 10

9 Determination of formaldehyde emission ........................................................................................ 12

10 Determination of steady-state emission value ................................................................................ 15

11 Expression of results ......................................................................................................................... 15

12 Test report ........................................................................................................................................... 16

Annex A (informative) Analytical procedure for the fluorimetric determination of

formaldehyde content ........................................................................................................................ 17

Bibliography ..................................................................................................................................................... 19

文档加载中……请稍候！
如果长时间未打开，您也可以点击刷新试试。

下载文档到电脑，查找使用更方便

亲，本站95%以上的标准规范都面向会员免费，办理VIP会员下载更省钱，平均每篇不到2元

立即下载 VIP免费下载

标签： #ISO

摘要：

ISO 12460-1-2007 是一项国际标准，专门规定了用于测定木基板材（如刨花板、纤维板、胶合板等）中甲醛释放量的试验方法——即干燥器法。该标准为木制品的环保性能评估提供了统一的技术规范，帮助制造商、检测机构和消费者准确识别产品是否符合低甲醛释放要求，尤其适用于进出口贸易和室内装修材料的质量管控。通过采用该标准，企业能够优化生产工艺，降低有害物质排放，从而提升产品的市场合规性与用户健康保障。

展开>> 收起<<

ISO 12460-1-2007.pdf

共26页,预览4页

还剩页未读，继续阅读

声明：本文档系会员上传，若文档所含内容侵犯了您的版权或隐私，请立即通知，我们立即给予侵权申诉删除！

ISO 12460-1-2007

相关推荐

开通VIP享超值会员特权

相关内容

热门标签

举报选择: